Demonstration mode, Controls operating the system – Philips FW540C User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS
OPERATING THE SYSTEM
[
2
i CENTER +/- (on FW748Premote
control only)
-
to adjust the sound level of the center
speaker.
TEST TONE (on FW748Premote
control only)
to check the sound level of the Front
Left, Front Right, Center and Surround
speakers.
g MUTE (on FW748P remote control
only)
-
to switch off the sound temporarily.
[|3 SIDE (available in model FW798W
only)
to change side when playing in Tape 2
mode.
M (!)
-
to switch the system to standby mode.
Notes for remote control:
- First select the source you wish to
control by pressing one of the
source select keys on the remote
control (e.g. CD, TUNER, TAPE V2 or
AUX),
- Then select the desired function
(PLAY, NEXT, etc.).
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
- During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
-
When the system is switched to standby
mode, the demonstration will resume
five seconds later.
the system only)
for
five seconds
when
the system is in demonstration mode.
-* The demonstration will stop.
-* "DEnO OFF " is displayed.
The system will switch to standby
mode.
Note:
- If the AC power cord is disconnected
and reconnected to the wall socket, the
demonstration will remain off until the
demonstration is switched on again.
14