Interlogix GE-DS-242-PoE - Manual (Page 85)

Chapter 4: Console Management
GE-DS-242-PoE Managed Ethernet Switch User Manual 81
This page includes the following fields:
OBJECT DESCRIPTION
RSTP mode
The user must enable the RSTP function first before configuring the
related parameters.
Protocol Version
A value used to specify the spanning tree protocol, the original
spanning tree protocol (STP, 802.1d) or the rapid spanning tree
protocol (RSTP, 802.1w).
Priority (0-61440)
The switch with the lowest value has the highest priority and is
selected as the root. If the value is changed, the user must reboot
the switch.
The value must be a multiple of 4096 according to the protocol
standard rule.
Max Age (6-40)
The number of seconds a switch waits without receiving Spanning-
tree Protocol configuration messages before attempting a
reconfiguration.
Enter a value between 6 through 40.
Hello Time (1-10)
The time that controls the switch to send out the BPDU packet to
check RSTP current status.
Enter a value between 1 through 10.
Forward Delay Time (4-
30)
The number of seconds a port waits before changing from its Rapid
Spanning-Tree Protocol learning and listening states to the
forwarding state.
Enter a value between 4 through 30.
NOTE: Follow the rule as below to configure the MAX Age, Hello Time, and
Forward Delay Time.
2 x (Forward Delay Time value -1) > = Max Age value >= 2 x (Hello Time value
+1).
NOTE: Each switch in a spanning-tree adopts the Hello Time, Forward Delay
time, and Max Age parameters of the root bridge, regardless of how it is
configured.
Root Bridge Information
This page provides a status overview for all RSTP bridge instances.