Interlogix GE-DS-242-PoE - Manual (Page 140)

Chapter 6: Command Line Interface
136 GE-DS-242-PoE Managed Ethernet Switch User Manual
Command Line Editing
Key Function
-B ;
←
Moves the cursor back one character.
-D Deletes the character at the cursor.
-E Jumps to the end of the current command line.
-F ; → Moves the cursor forward one character.
-K Deletes from the cursor to the end of the command line.
-N ; ↓ Enters the next command line in the command history.
-P ; ↑ Enters the previous command line in the command history.
-U Deletes from the cursor to the beginning of the command line.
-W Deletes the last word typed.
B Moves the cursor backward one word.
D Deletes from the cursor to the end of the word.
F Moves the cursor forward one word.
Delete the character before the cursor.
Delete the character at the cursor.
The following generic function keys provide functions in all of the menus:
Command Help
You may enter ? at any command mode, and the CLI will return possible
commands at that point, along with some description of the command.
System Commands
Command Description
show running-config Display the running configuration of the switch.
copy running-config
startup-config Backup the switch configurations.
erase startup-config Reset to default factory settings at next boot time.
clear arp <ip-addr> specifies the IP address to be cleared. If no IP
address is entered, the entire ARP cache is cleared.
show arp Show the IP ARP translation table.
ping Send ICMP ECHO_REQUEST to network hosts.
Parameters: <1..999> specifies the number of repetitions. If
not entered, it will continue to ping until you press -C to
stop.