Interlogix GE-DS-242-PoE - Manual (Page 216)

Appendix A: RJ-45 Pin Assignment
212 GE-DS-242-PoE Managed Ethernet Switch User Manual
10/100Mbps, 10/100Base-TX
When connecting your 10/100Mbps Ethernet Switch to another switch, a bridge
or a hub, a straight or crossover cable is necessary. Each port of the Switch
supports auto-MDI/MDI-X detection. That means you can directly connect the
Switch to any Ethernet devices without making a crossover cable. The following
table and diagram show the standard RJ-45 receptacle/ connector and their pin
assignments:
RJ-45 Connector pin assignment
Contact MDI
Media Dependant Interface
MDI-X
Media Dependant Interface-Cross
1 Tx + (transmit) Rx + (receive)
2 Tx - (transmit) Rx - (receive)
3 Rx + (receive) Tx + (transmit)
4, 5 Not used
6 Rx - (receive) Tx - (transmit)
7, 8 Not used
The standard cable, RJ-45 pin assignment
1 2 3 4 5 6 7 8
8 7 6 5 4 3 2 1
The standard RJ-45 receptacle/connector
There are 8 wires on a standard UTP/STP cable and each wire is color-coded.
The following shows the pin allocation and color of straight cable and crossover
cable connection: