Interlogix NX-540E - Manual (Page 27)

Page 27
LOCAL TELEPHONE COMPANY INTERFACE
TELEPHONE CONNECTION REQUIREMENTS
Except for telephone company provided ringers, all connections to the telephone network shall be made
through standard plugs and standard telephone company provided jacks or equivalent in such a manner
as to allow for immediate disconnection of the terminal equipment. Standard jacks shall be so
arranged that if the plug connected thereto is withdrawn, no interference to the operation of the
equipment at the customers’ premises which remains connected to the telephone network, shall occur
by reason of such withdrawal.
INCIDENCE OF HARM
Should terminal equipment or protective circuitry cause harm to the telephone network, the telephone
company shall, where practical, notify the customer that temporary discontinuance of service may be
required. However, where prior notice is not practical, the telephone company may temporarily
discontinue service if such action is deemed reasonable in the circumstances. In the case of such
temporary discontinuance, the telephone company shall promptly notify the customer who will be given
the opportunity to correct the situation. The customer also has the right to bring a complaint to the FCC
if he feels the disconnection is not warranted.
CHANGES IN TELEPHONE COMPANY EQUIPMENT OR FACILITIES
The telephone company may make changes in its communications facilities, equipment, operations, or
procedures where such action is reasonably required and proper in its business. Should any such
change render the customers terminal equipment incompatible with the telephone company facilities,
the customer shall be given adequate notice to make modifications to maintain uninterrupted service.
GENERAL
The FCC prohibits customer provided terminal equipment be connected to party lines.
IMPORTANCE OF THE RINGER EQUIVALENCE NUMBER
The Ringer Equivalence Number (REN) of this device is 0.1B. This number is a representation of the
electrical load that it applies to your telephone line.
MALFUNCTION OF THE EQUIPMENT
In the event that the device should fail to operate properly, the customer shall disconnect the
equipment from the telephone line to determine if it is the customers equipment that is not functioning
properly. If the problem is with the device, the customer shall discontinue use until it is repaired.
EQUIPMENT INFORMATION
The NetworX NX-540E meets FCC Part 15, Class B verification requirements and FCC Part 68
modification.
MANUFACTURER OF CONNECTING EQUIPMENT: CADDX CONTROLS, INC.
FCC REGISTRATION NUMBER: GCQUSA-30138-AL-E, RINGER EQUIVALENCE: 0.1 B