IC Realtime IP High Speed PTZ Dome Camera with 36X Zoom and WDR (ICIPZ3601WDR) - Manual (Page 28)

21
IDLE FUNC ： OFF
IDLE TIME ： 010MIN
IDLE ACTION ：PRESET
PRESET NO ：001
AUTO SCAN NO ：001
CRUISE NO ： 001
PATTERN NO ：001
SAVE
BACK
EXIT
z PROGRAM START: Here is to memorize pattern starting point. An icon OK pops up in screen to prompt
you system begins memory pattern.
z PROGRAM STOP ：Here is to set pattern stop point. After all the movement, move the cursor to
PROGRAM STOP and then click confirm button. Now you have set one pattern. System pops up an
icon OK to prompt you system has memories one pattern.
z RUN ：Here is to activate pattern. Input pattern number, move the cursor to RUN and click confirm
button, system begins running pattern.
z STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click confirm
button. System stops current pattern.
z BACK: Go back to previous menu.
z EXIT: Log out system menu.
Note:
z The dwell time between two orders should be less than one minute, otherwise system will set to default
value as one minute.
z After click PROGRAM STOP, do not click CALL button before icon “●” disappears completely.
z Any manual operation during the pattern procedure will terminate current dome pattern operation.
5.4.4.6 Idle Function
When there is no available command for specified time, dome automatically goes on the previous set
functions.
• IDLE FUNCTION ： There are two modes ON/OFF. Please use left/right key to set.
• IDLE TIME: System idle period. Please use the left/right button on the keyboard or in the speed
dome terminal menu to set.
• IDLE ACTION：There are several functions you can select:
NONE/PRESET/SCAN/TOURING/PATTERN. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set.
• PRESET NO： Here is for you to set preset number. The value ranges from 1 to 255. System goes
to specified preset when idle status is on.
• AUTO SCAN NO： The value ranges from 1 to 5. Please use the left/right button on the keyboard or
in the speed dome terminal menu to set. System begins specified scan when idle status is on.
• CRUISE NO： The value ranges from 1 to 8. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. System begins specified touring when idle status is on.