IC Realtime Flex Series: 64 Channel 2CIF 3U Standalone DVR User Manual
Page 76
66
for you to use the special keyboard to control the device. PTZ matrix is to connect to the
peripheral matrix control.
z
Baud rate: You can select proper baud rate.
z
Data bit: You can select proper data bit. The value ranges from 5 to 8.
z
Stop bit: There are three values: 1/1.5/2.
z
Parity: there are five choices: none/odd/even/space mark.
System default setup is:
z
Function:
Console
z
Baud
rate:115200
z
Data
bit:8
z
Stop
bit:1
z
Parity:
None
After completing all the setups please click save button, system goes back to the previous menu.
Figure 5-8
5.3.5 Network
Here is for you to input network information. See Figure 5-9.
z
MAC address: The host in the LAN can get a unique MAC address. It is for you to access in the
LAN. It is read-only.
z
IP address: Here you can use up/down button (
ST
) or input the corresponding number to
input IP address. Then you can set the corresponding subnet mask the default gateway.
z
Subnet prefix: The input value ranges from 0 to 128. It is to mark a specified network MAC
address. Usually it includes an organization of multiple-level.
z
Default gateway: Here you can input the default gateway. Please note system needs to
check the validity of all IPv6 addresses. The IP address and the default gateway shall
be in the same IP section. That is to say, the specified length of the subnet prefix shall
have the same string.