Heckler&Koch MR762A1-LRP User Manual

Page 27

SLING AND ADAPTOR – The MR762A1-LRP is equipped with a simple and state of the

art VCAS sling system made by Blue Force Gear. The sling is one of the most under-used

aspects of marksmanship to provide proper support and steady the rifle.

Fig. 76 – Sling Components

Fig. 77 a,b,c,d – VCAS Sling Installation on G28 Buttstock

To attach the sling start with the buttstock end. Remove the keeper from the sling and

slide the sling webbing through the desired location on the buttstock (recommend left

side for left hand shooter). With the loose end of the sling webbing showing through the

buttstock, re-attach the keeper as a locking device.

Attach the sling rail adaptor (RMFL) to the Free Floating Rail System by removing the

screw in the RMFL and sliding the adaptor over the Picatinny rail to the desired location.

Re-install the screw to hold it in place. Recommend having the screw in the top position

and recommend locating the sling adaptor on the left side for a right-handed shooter at

about the midway point of the rail system.

Fig. 78 a,b,c – Sling hardware installation

For target shooter who will be using the sling as a primary means of support then

recommend attaching the sling adaptor to the bottom of the rail at the midway point.

Thread the loose sling webbing of the muzzle end of the sling through the sling adaptor

and tighten. For more information, visit www.blueforcegear.com.

For additional information on MR762A1 LRP configuration and maintenance

recommendations, including any service bulletins, please contact HK customer service at

[email protected] or call 706-568-1906