GTCO AccuTab II - Users Guide User Manual
Page 58
AccuTab II 58
GTCO Commands:
Send command CL; to set a new increment
value, send command IV and at the prompt,
send three digits representing the new
increment in units of 0.001”.
Remote Request Mode
In Remote Request Mode, one coordinate is sent when the Controller receives a Read
Current Coordinate command (CTRL-B).
To select Remote Request Mode:
Custom Configuration Menu:
GTCO Commands:
Not available.
Send command RM.
Controlling the Alarm Using Remote Commands
An alarm (audio tone) is provided so the AccuTab II can inform you of certain conditions.
The alarm can be enabled or disabled by the
Menu or commands.
To hear only critical tones, turn the alarm off:
AccuSet Menu:
GTCO Commands:
Select the Alarm menu block
Send command AD.
To hear all tones, turn the alarm on:
AccuSet Menu:
GTCO Commands:
Select the Alarm menu block.
Send command AE.
When you move the cursor over the Alarm block on the AccuSet Menu, the Proximity
indicator (
green
) will light if the alarm is currently enabled.