GTCO AccuTab II - Users Guide - Manual (Page 17)

AccuTab II 17
Controlling the Alarm
There are two ways to toggle the alarm on or off:
 Select the block on the AccuSet Menu.
 Use the below remote commands.
Controlling the Alarm Using Remote Commands
An alarm (audio tone) is provided so AccuTab II can inform you of certain conditions. The
alarm can be enabled or disabled by the AccuSet Menu or commands.
To hear only critical tones, turn the alarm off:
AccuSet Menu:
Select the menu block
GTCO Commands: Send command AD.
To hear all tones, turn the alarm on:
AccuSet Menu:
Select the menu block
GTCO Commands: Send command AE.
When you move the cursor over the block on the AccuSet Menu, the Proximity
indicator ( red ) will light if the alarm is currently enabled.
Resetting AccuTab II
There are three ways to reset AccuTab II:
 Enter AccuSet code 00 on the AccuSet Menu.
 Turn power off and on.
 Send remote commands described in the Advanced Operating Information section.
When one of these events occurs, AccuTab II will revert to the configuration that was last
defined. Any remote commands that were active before the result will be lost.