beautypg.com

Get the model ready to fly, Check the control directions and center the servos, Apply the decals – Great Planes Venus II 60 ARF - GPMA1027 User Manual

Page 23

background image

4. Mount the canopy to the fuselage with four #2 x 3/8"

[9.5 mm] button-head screws. Remove the screws and
canopy, harden the holes with thin CA, allow to harden, and
then mount the canopy.

1. Use scissors or a sharp hobby knife to cut the decals from
the sheet.

2. Be certain the model is clean and free from oily
fingerprints and dust. Prepare a dishpan or small bucket with
a mixture of liquid dish soap and warm water—about one
teaspoon of soap per gallon of water. Submerse the decal in
the soap and water and peel off the paper backing. Note:
Even though the decals have a “sticky-back” and are not the
water transfer type, submersing them in soap & water allows
accurate positioning and reduces air bubbles underneath.

3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.

4. Use a piece of soft balsa or something similar to
squeegee remaining water from under the decal. Apply the
rest of the decals the same way.

1. With the radio system connected and operating, turn

on the transmitter and receiver.

2. Make certain that the control surfaces and the carburetor

respond in the correct direction. If necessary, use the servo
reversing to reverse any servos that are going the wrong way.

3. Center all the trims on the transmitter. Starting with the

rudder servo and with the radio on, test-fit the four-arm
servo arm in one of the four positions until you find the one
that is 90-degrees. Cut off the remaining arms. Repeat for
the rest of the servos.

90°

NO

NO

NO

YE

S

90-DEGREES!

NOTE THE NUMBER

S

ON EACH ARM.

ROTATE THE ARM UNTIL YOU FIND ONE
THAT I

S

90˚, THEN CUT OFF THE OTHER

S

.

2

3

4

1

2

CARBURETOR WIDE OPEN

RUDDER MOVES RIGHT

LEFT AILERON MOVES DOWN

RIGHT AILERON MOVES UP

ELEVATOR MOVES UP

4-CHANNEL

TRANSMITTER

(STANDARD MODE 2)

4-CHANNEL RADIO SETUP

TRANSMITTER

4-CHANNEL

TRANSMITTER

4-CHANNEL

TRANSMITTER

4-CHANNEL

Check the Control Directions

and Center the Servos

GET THE MODEL READY TO FLY

Apply the Decals

23