Great Planes RC Universe FlatOuts ARF - GPMA1117 - Manual (Page 11)

❏
1. Cut the wings and all four ailerons free from the foam
sheet. Identify the top and bottom wings. The bottom wing has
the aileron servo bay. Locate the 3 x 650 mm [1/8" x 25-9/16"]
wing leading edge tubes. Glue these tubes to both the top
and bottom wings.
❏
2. As you did with the rudder and elevators, slide two
hinge retainer rings (C3) onto each of the four wing trailing
edge tubes to be centered in the notches in the wing. Glue
the rings to the tubes and glue the tubes to the wings.
❏
3. Clip the upper and lower ailerons to the trailing edge
tubes with clip hinges (C2) and glue the hinges into place.
❏
4. Slide the bottom wing into the cutout in the fuselage
and center it laterally and perpendicular to the fuselage.
When satisfied with the fit, glue the lower wing to the
fuselage by running a bead of glue down each corner where
the wing and fuse meet.
❏
5. Cut two stand-alone control horns (B1) and two stand-
alone control horn retainers (B2) from the parts tree.
Enlarge the holes with a #38 (.101") drill bit.
❏
6. Insert the control horns into the slots in the lower
ailerons with the hole in the horn pointing down and
positioned over the hinge line. Press the control horn
retainers onto the control horns and secure them with a few
drops of glue.
Assemble the Wing
11