Set the clock 9, Menu, Button – Philips VR350 User Manual
Page 9: Clear, Status, Number, Buttons, Set the clock, R to reset the clock, Make sure
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Set the Clock 9
0
set your VCR to the present day and time, follow steps 1-4 below. Once set, your VCR (Video Cassette Recorder)
will maintain the time in its internal clock, and will make timer recording possible.
MENU
‘Button
.CLEAR
Button
.STATUS
Button
NUMBER
Buttons
-| Make sure... |--------------------------------------------------------------
• your VCR and TV are connected and turned on.
• the VCR indicator says “VCR”.
• to make each entry within 10 seconds, otherwise the VCR will exit
the Clock Set mode and you will have to start over.
S Select the Clock Set Mode
T
--------------------- ^—
1 Press the MENU button. Then press the 5
TIME -
J
button to select “CLOCK SET” from the
menu screen.
TOENDPUSHMENU j
_
Set the Time & AM or PM
I First, press two NUMBER buttons for the hour, then two NUMBER
^ buttons for the minutes, and finally press “1” for AM or “2” for PM.
For example, for 10:30 PM, press the NUMBER buttons 1-0,3-0,2.
When setting the clock for the first time, entries that do not
match the VCR’s internal calendar will cause a “?” to appear.
Always enter “0” before any single-number entries.
To make corrections, press the CLEAR button repeatedly to move
back to an item then enter the correct number.
Set the Month, Day & Year
I Press two numbers for the month, two
numbers for the day, and two numbers for
the year.
For example, for July 1,1995, press the
NUMBER buttons 0-7,0-1,9-5.
TIME 1050 PM
MONTH
TO CORRECT PUSH CLEAR
TO END PU^MENU
DATE 07,01/95
SAT,
TO CORRECT RJSH CLEAR
TO END PUSH MENU
Start the Clock
i Press the MENU button.
Clock starts and the screen returns to the program you were on.
To display the time, press the STATUS button.
r To Reset the Clock
Press the MENU button. The TV and VCR must be on and the VCR
in the “VCR” mode. The menu screen will appear. Press the
NUMBER 5 button and foUow the clock set
guide to re-enter the new date and time.
TO SEIECT PUSH NO SHOWN
1 PROGRAM
2 VCR SET UP
3 TUNER SET UP
4 INPUT SELECT
5 CLOCK SET
. TOENDPUSHMENU
Power failures can cause you to lose your clock setting placed in the
VCR’s memoiy. Should this happen, repeat steps on pages 8 and 9
before doing anything else.
Your VCR should now be properly set-up.
Go to the next page and try playing a tape.