Operating instructions philips vr800/07, Safety instructions and other notes, Video – Philips VR800 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING INSTRUCTIONS PHILIPS VR800/07
Congratulations
on the purchase of one ofthe mostsophisti-
1.
Gated and simple-to-use video recorders
(VCR)
on the market.
With this VCR you can record and play VHS-standard
cassettes.
VMS
Please take the time to read this operating manual before
using your video recorder.
Safety instructions and other notes
A
A
A
Danger: High voltage!
Do not remove the top cover as there is a risk of an electrical
shock!
The video recorder does not contain any components that can
be repaired by the customer. When the appliance is connected
to the power supply there are some components that are
constantly operational. To switch off the video recorder
completely you must disconnect it from the power supply.
Note that this power pack is designed for a power supply of
220-240V/50HZ.
A
i\ Ensure that air can circulate freely through the ventilation slots
on the video recorder.
A
Ensure that no objects or liquids enterthe video recorder. If
liquid is spilt into it, disconnect the video recorder immediately
from the power supply and call the After-sales Service for
advice.
/K The video recorder should not be used immediately after
transportation from a cold to a hot area or vice versa, or in
conditions of extreme humidity.
After unpacking the video recorder, it should be allowed to
acclimatize for at least three hours before installation.
0
These operating instructions have been printed on nonpolluting
paper.
Deposit old batteries at the relevant collection points.
Please make use ofthe facilities available in your country for
disposing ofthe packaging ofthe video recorderin a way that
helps to protectthe environment.
This electronic equipment contains many materials that can be
recycled. Please inquire about the possibilities for recycling
your old set.
VIDEO Plus+ and PlusCode are registered trademarks of
Gemstar Development Corporation. The VIDEO Plus+ system is
manufactured under licence from Gemstar Development Cor
poration.
VIDEO
INSTALLATION...................................................................................2
Connecting to the TV-set.............................................................. 2
Initial Installation.............................................................................. 4
Successive Installation ................................................................... 4
Automatic TV Channel Allocation (FOLLOWTV)................... 4
Connecting a decoder or additional equipment..................4
Manual TV Channel Search...........................................................5
Monitor function ............................................................................. 6
Sort/Clear TV channels manually............................................... 6
Setting the clock and the date ...................................................6
User guide (OSD)..............................................................................7
Emergency interrupt....................................................................... 7
Saving energy.................................................................................... 7
Playback a cassette..........................................................................8
Searching fortape position........................................................... 8
Still picture/Slow motion ..............................................................8
Eliminating picture interference................................................. 9
MANUAL RECORDING ................................................................ 10
Recording with/without automatic switch-off ....................10
Automatic recording from a satellite receiver (SAT
RECORDING)................................................................................... 11
Direct Record.................................................................................. 11
AUTOMATIC (PROGRAMMED) RECORDING....................... 12
'VPS' (Video Programming System)/'PDC' (Pro
gramme Delivery Control) .........................................................12
'.......................................... 12
Manual programming without'VIDEO Plus+' ....................13
Howto check or alter a TIMER...................................................14
'NexTViewLink'.................................................................................14
ADDITIONAL FUNCTIONS...........................................................15
Switching the remote control command ............................ 15
Continuous playback ...................................................................16
The automatic switch-off............................................................ 16
Remote control of TV sets..........................................................17
Audio dubbing................................................................................ 18
Selecting the sound track........................................................... 19
Synchronous editing (synchro-edit)....................................... 19
Before you call an engineer ..................................................... 21