Philips FW-M55 - Manual (Page 31)

- During rewinding or fast forwarding of
a tape, it is also possible to select
another source (e.g. CD, TUNER, or
AUX).
O
CLOCK TIMER
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD,TUNER,
etc.). The clock will be displayed for
about seven seconds.
• Press CLOCK/TIMER briefly.
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
— “...... •••’’will be displayed if the
clock is not set.
5 Press CLOCK/TIMER again to
store the setting.
“*■ The clock starts.
• To exit without storing the setting,
press ■ on the system.
Notes:
- During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
- When a power interruption occurs, the
clock setting is erased.
Clock Setting
The clock can be set in either 12- or
24-hour mode, e.g. “FiM 1 2 - 0 0 “ o r
“ 0 0 - 0 0 " . Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select
clock mode.
2 Press PROG (on the system only) to
select 12- or 24- hour mode.
If 12-hour mode is selected,
“Firi / 2 - 0 0 “ starts flashing.
^ If 24-hour mode is selected,
“ 0 0 - O O ” starts flashing.
3 Set the hour with « or ►► on the
system.
4 Set the minute with M or ►! on
the system.
Timer Setting
• The system can switch on to CD,
TUNER, orTAPE 2 mode
automatically at a preset time. It can
serve as an alarm to wake you up.
• Before setting the timer; make sure
the dock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum
level until the volume level
before the set is switched to
standby mode.
1 Press and hold CLOCK/TIMER for
more than two seconds to select
timer mode.
“ fin 1 2 - 0 0 ” o r “ u n : u u " or
the last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
The
TIMER starts flashing.
The selected source is lit while
other available sources are
flashing.
2 Press CD, TUNER or TAPE to
select the desired source.
• Before selecting CD orTAPE, make
sure a disc or tape is loaded in the
disc tray or tape deck 2.
3 Press -44 or ►► on the system to set
the hour for the timer to start.