beautypg.com

General information, Environmental, Information – Philips FW-M55 User Manual

Page 14: Safety information, General information safety information, Environmental information, Accessories

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

product, you must return your Warranty
Registration Card within 10 days. So please mail

it to us right now!

O

GENERAL INFORMATION

SAFETY INFORMATION

General Information

The typeplate (which contains

the serial number) is located at

the rear of the system.

Recording is permissible if

copyright or other rights of third

parties are not infringed.

This device complies with the

Federal Communications

Commission (FCC) rules, part IS

and with 21 CFR 1040.10.
Operation is subject to the

following two conditions:
- This device may not cause

harmful interference, and

- This device must accept any

interference received, including

interference that may cause

undesired operation.

Environmental
Information

All unnecessary packaging has been

omitted. We have tried to make the

packaging easy to separate into three

materials: cardboard (box), polystyrene

foam (buffer) and polyethylene (bags,

protective foam sheet).

Your system consists of materials which

can be recycled and reused if
disassembled by a specialized company.

Please observe the local regulations
regarding the disposal of packaging

materials, exhausted batteries and old

equipment

Accessories

(Supplied)

- Remote control

- Batteries (two AA size) for remote

control

- AM loop antenna

- FM wire antenna

- AC power cord

Safety Information

• Before operating the system, check

that the operating voltage indicated

on the typeplate (or the voltage

indication beside the voltage

selector) of your system is identical

with the voltage of your local power

supply. If not please consult your

dealenThe typeplate is located at the

rear of your system.

• When the system is switched on, do

not move it around.

• Place the system on a solid base (e.g.

a cabinet).

• Place the system In a location with

adequate ventilation to prevent

internal heat build-up in your system.

Allow at least 10cm (4 inches)

clearance from the rear and the top

of the unit and 5cm (2 inches) from

the each side.

• Do not expose the system to

excessive moisture, rain, sand or heat

sources.

• Under no circumstances should you

repair the system yourself as this will

invalidate the warranty!

• If the system is brought directly from

a cold to a warm location, or is

placed in a very damp room,

moisture may condense on the lens
of the CD unit inside the system.

Should this occur the CD player will

not operate normally. Leave the

power on for about one hour with

no disc in the system until normal
playback is possible,

• Electrostatic discharge may cause

unexpected problems. See whether

these problems disappear If you

unplug the AC power cord and plug

it in again after a few seconds.

® To disconnect the system from

the power supply completely,

remove the AC power plug

from the wall socket.

This manual is related to the following products: