Philips FW-M55 - Manual (Page 25)

TUNER
Note:
- For 'EASY SET feature, please refer to
page 13.
Tuning to radio stations
1 Press TUNER (FM*AM) to select
TUNER mode.
— “
” will be displayed.
A few seconds later the current
radio frequency will be displayed.
2 Press TUNER (FM*AM) again to
select the desired waveband ; FM or
AM.
3 Press or ►► for more than one
second, then release.
-* The display will show‘‘bhFlKLH”
until a radio station with sufficient
signal strength is found.
Repeat this procedure until the
desired radio station is reached.
To tune to a weak radio station,
briefly press or ►> repeatedly
until the display shows the desired
frequency and/or when the best
reception has been obtained.
Storing Preset Stations
You can store up to 40 radio stations in
the memory. When a preset radio
station is selected, the preset number
appears next to the frequency on the
display.
Automatic programming
1 Press TUNER (FM*AM).
2 Press PROG for more than one
second.
— The PROGRAM starts flashing and
“HUT0”will be displayed.
— The system will search for every
available radio station in the FM
waveband first, then search the
AM waveband.
— All available radio stations will be
stored automatically.The
frequency and preset number will
be displayed briefly.
—■ The system will stop searching
when all the available radio
stations are stored or when the
memory for 40 preset radio
stations is used.
-*■ The system will remain tuned to
the last stored preset radio
station.
Notes:
- You can cancel the automatic
programming by pressing PROG or ■
(on the system only).
- If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10
before starting automatic programming,
only the preset numbers 10 to 40 will
be programmed.
Manual programming
1 Press TUNER (FM*AM).
2 Press TUNER (FM*AM) again to
select the desired waveband : FM or
AM.
3 Press PROG for less than one
second.
-* The PROGRAM starts flashing.
-* The next available preset number
will be displayed for selection.
4 Press or ►► to tune to the
desired frequency.
* If you wish to store the radio station
to another preset number; press ▼
or ▲ to select the desired preset
number
5 Press PROG again.
—' The PROGRAM disappears and the
radio station will be stored.
* Repeat steps 3 -5 to store other
preset radio stations.
Notes:
- When 40 radio stations are stored and
you attempt to store another radio
station, the display will show “FULL".
If you want to change an existing
preset number, repeat steps 3 - 5 .