Philips FW-M55 - Manual (Page 30)

RECORDING
Dubbing tapes
(from tape deck 1
to tape deck 2)
1 Press TAPE (TAPE 1 *2 ) to select
tape deck 2.
2 Load the prerecorded tape into tape
deck 1 with full spool to the left and
a blank tape into tape deck 2 with
full spool aside,
3 Press M or ►! to select the
recording tape side (see Tape Side
under TAPE section).
4 Press DUB (HSD) once for
normal speed dubbing or twice
(within 2 seconds) for high speed
dubbing.
‘ nORi'lHL" (normal speed) or
“FHST” (high speed) will be
displayed,followed b y ' u u f c i “ with
“< or .'■■■ ” scrolling left or right
depending on the tape side
selected.
The
HSD appears on the display
during high speed dubbing.
• Dubbing will start immediately.
The REC starts flashing.
5 Press ■ to stop dubbing.
Notes:
- Only ~Z. mode is available during
dubbing.
- At the end of side A, flip the tapes to
side B and repeat the procedure.
- Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
- To ensure good dubbing, use tapes of
the same length.
- During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
- You can listen to another source while
dubbing.
CD/MP3-CD Synchro
Start Recording
1 Load a blank tape into tape deck 2
and a disc into a disc tray.
2 Press CD to select CD/MP3-CD
mode.
• You can program the tracks in the
order you want them to be recorded
(see ProgrammingTracks). If not,
select the disc by pressing CD (CD
1 * 2 * 3 ) and the tracks are recorded
according to the order on the
selected disc.
3 Press REC to start recording.
— The REC starts flashing.
• Disc will start playback automatically.
4 Press ■ to stop recording.
One Touch Recording
• For One Touch Recording, as soon as
you press REC, the current source
(CD,TUNER or AUX) will be
recorded on tape deck 2.
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
The REC starts flashing.
3 Press ■ to stop recording.
Note:
- When you press RECORD while in
TAPE mode,' "
will be displayed. One Touch Recording
is not possible in TAPE mode.