FingerTec AdapTec Plus - Manual (Page 12)

12
AdapTec Plus
Access Control/Power Output Module
To Battery Tamper Siren EM Output Siren Door Wiegand
Switch Output 12V Voltage Accept Exit Input
- + Input 12V 0V GND WD0 WD1
DC 12V
Rechargeable
Backup
Battery
Connection
Points
ALM+
ALM-
GND
+12V
Release
Button
Alarm
Siren
+ _
CONNECTING ADAPTEC PLUS TO AN
ALARM SIREN
For all FingerTec door access control models, there
is a security button behind the terminal. During nor-
mal operation, the security button is compressed and
once the terminal is dismantled, the button will be
released and
“System broken” message will appear
onscreen.
During the release of the button, the terminal will output an alarm sig-
nal. Nonetheless, no alarm sound will be emitted if the terminal is not
equipped with a preinstalled siren.
To use the siren feature, we recommend you to install an additional alarm
siren and connect it to the FingerTec terminals.
Benefi ts of using AdapTec plus with Alarm Siren
We recommend you to install a terminal along with an AdapTec Plus if
you plan to use the alarm siren. In the AdapTec Plus, an additional port
is readily built to receive the alarm signal from the FingerTec terminals.
the AdapTec Plus has an output of DC12V and it is suitable to use with
an alarm siren that has the same power input. You do not need to source
and additional DC12V power supply for this purpose. Furthermore, the
AdapTec Plus provides a “Siren Accept” button where you can press the
button to deactivate alarm siren when required.
FUNCTION • R2, Kadex and m-Kadex
Connect the terminal, alarm siren and AdapTec Plus as illustrated below.
STEP 1 • Wiring Diagram
Remark:
Set Auto Alarm in terminal to N.
Menu > Options > Sys Opt > Adv Opt > Auto Alarm > N.