A021, Master-slave configuration – Eliminator Lighting Electro Strip User Manual

Page 3

4. If you would like to add strobing to the color change program, press ENTER after you have set the color

change speed, “F.000” will now be displayed. Press the UP or DOWN buttons to adjust the strobing speed.

Once you have found your desired speed press the MODE button twice to go back to your color change pro-

gram.
4. To exit the running modes completely, press the MODE button three times.

A014 - A020 -

there are 7 color chases to choose from. The speed of the chase is adjustable

in all 7 chases. Flash (strobe) is not available for these chases.

1. Once you have followed the directions listed under section “A000” you can now select and run different

color chase programs.
2. A014 - A020 are your color chase programs. Each number 14-20 represents a different color chase pro-

gram.
3. Press the UP and DOWN buttons to scroll through the different chases. Once you have found your desired

chase press ENTER. “P.XXX” will be displayed, this is chase speed adjustment. Use the UP or DOWN buttons

to adjust the speed of the color chase. Once you have found your desired color chase speed you can leave

the unit as is or press MENU so that your selected program number is displayed. This mode can also be run

by sound activity, adjust the sensitivity knob located on the rear to make the unit more senstive or less sensi-

tive to sound. Turning the knob clockwise makes it the more sensitive, counter-clockwis makes it less sensi-

tive.
4. To exit the running modes completely press MENU three times.

A021 -

in this mode you can control manually control the RGB colors.

1. Once you have followed the directions listed under section “A000” you can now manually adjust the RGB

colors to create your own desirable static color.
2. A021 is your RGB mode. When A021 is displayed press ENTER. “P.XXX” will be displayed, this is the Red

adjustment. Use the UP and DOWN buttons to adjust the intensity of Red. Once you have found your desired

intensity press ENTER.
3. When you press ENTER after adjusting the Red color, “F.XXX” will be displayed. This is the Green inten-

sity adjustment. Use the UP and DOWN buttons to adjust the intensity of Green. Once you have found your

desired intensity press ENTER.
4. When you press ENTER after adjusting the Green color, “C.XXX” will be displayed. This is the Blue intensity

adjustment. Use the UP and DOWN buttons to adjust the intensity of Blue. Once you have found your desired

intensity press ENTER.
3. Continue to adjust the colors until you produce your desired color. Once you have made your desired color

leave the unit as is. To exit the RGB mode completely press the MODE button.

Master-Slave Configuration:

This function will allows you to link units together to run in a Master-Slave mode. In Master-Slave operation

one unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any

unit can act as a Master or as a Slave however, only one unit can be programmed to act as the “Master.”
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR microphone cables

to link your units together. Remember that the Male XLR connector is the input and the Female XLR connec-

tor is the output. The first unit in the chain (master) will use the female XLR connector only. The last unit in the

chain will use the male XLR connector only.
2. Using the Master unit, choose your desired operating mode and connect the “Slave” unit or units.
3. Turn “On” all of the slave units first, then turn “On” the Master unit last. All slave units will automatically

sync to the Master unit.