Disp, Test, Fhrs – Eliminator Lighting Mirage LED User Manual

Page 3: Rest

LED -

With this function you can have the LED display turn off after 10 seconds.

1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to

keep the LED display on at all times, or “OFF” to switch to have the LED display switch off after 10

seconds. To make the display reappear, press and hold the MENU button for at least 5 secs.
3. Press ENTER to confirm. To make the display reappear, press and hold the MENU button for at

least 5 secs.

DISP

- This will “flip” the LED display

1. Press the MENU button until “DISP” is displayed, press ENTER.
2. When “DISP” is displayed the LED display will remain normal, when “DSIP” is displayed, the LED

display will be “flipped”. Use the ENTER button to find your desired display set up, then press MENU

to confirm and exit.

TEST

- This function will run a self test program.

1. Press the MENU button until “TEST” is displayed, press ENTER.
2. The fixture will now run a self test. Press the MENU button to exit.

FHRS

- With this function you can display the running time of the unit.

1. Tap the either the MENU button until “FHRS” is displayed, press ENTER.
2. The display shows the running time of the unit. Press MENU to exit.

VER

- Use this function to display the Software version of the unit.

1. Tap the either the MENU button until “VER” is displayed, press ENTER.
2. The display will show the software version.

REST

- This function will reset the unit to its factory settings.

1. Press the MENU button until “REST” is displayed, press ENTER.
2. The fixture will now reset itself. Press the MENU button to exit.