Addr, Slnd, Shnd: sh 0 – Eliminator Lighting Mirage LED User Manual

Page 2: Sh 8, Soun, Sens, Blnd

ADDR -

DMX Address Setting.

1. Tap the either the MENU, UP, or DOWN buttons until “ADDR” is displayed, press ENTER.
2. “1” will now be displayed and flashing. Press the UP or DOWN buttons to find your desired

address. Press ENTER to set your desired DMX address.

SLND -

This will let you set unit as a slave in a master/slave configuration.

1. Tap the either the MENU button until “SLND” is displayed, press ENTER. “SL 1”or “SL 2” will be

displayed.
2. Tap the UP or DOWN buttons until your desired setting is displayed, press ENTER to confim and

exit.

SHND: SH 0

SH 8

- Show modes 0 - 8 & Manual show. Show mode can run with or

without sound active mode on.
1. Press the MENU button until “SHND” is displayed, press ENTER.
2. “SH X” will now be displayed, “X” representing a number between 0-8 will be displayed. Shows 1-8

are preset shows, while “SH 0” is random show. Press the UP or DOWN buttons to find your desired

show.
3. Once you have found your desired show press ENTER, and then press and hold the MENU button

for at least 3 seconds to confirm.

SOUN

- In this submenu you can activate sound active mode.

1. Press the MENU button until “SOUN” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or DOWN buttons to select one or the

other.
3. When you have made your selection, press the ENTER, and then press and hold the MENU button

for at least 3 seconds to confirm.

SENS

- Sound sensitivity control.

1. Press the MENU button until “SENS” is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or DOWN buttons to adjust the

sound sensitivity. 0 being the least sensitive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button for at least 3 seconds to confirm.

BLND -

Blackout or Stand by mode.

1. Tap the either the MENU button until “BLND” is displayed, press ENTER. Either Yes or No will be

displayed.
2. To activate Blackout tap the UP or DOWN buttons until Yes is displayed, press ENTER to confim

and exit. The fixture will now be in Blackout mode. To deactivate Blackout mode, select No and

press Enter.