Dynaflite DYFA3040 - Manual (Page 23)

U U 27. Using a 1/4" bit, drill a hole through the
landing gear rail into the stub block. Radius the
top of the hole to fit the bend in the 1/4" landing
gear wire. (See the photo at step 26.)
U U 1. Prepare the wing panels for joining by
cutting a 1/16" wide slot in front of and behind
the spars in W1 as shown in the photo.
Q Q 28. Glue a 3/32" x 15/16" x 24" balsa TE
sheet to the bottom of the inner TE and ribs
using aliphatic glue. Note that the sheeting
extends from W1 to W7 and is trimmed at an
angle. Use your straightedge to keep W1
straight.
Q Q 29. Glue a 3/32" x 15/16" x 24" balsaTE sheet
to the bottom of the outer TE and ribs using
aliphatic glue. Note that the sheeting extends
from W7 to W12 and is trimmed at an angle.
Q Q 30.Trim theTE sheeting even with ribsW1
andW12.
Q 31. Return to step one and assemble the left
wing panel.
Q 2.Test fit the die-cut 1/16" ply dihedral braces
to the wing panels. The shorter ply brace goes
on the forward side of the spars. When satisfied
with the fit, glue the braces to left wing panel
with 30-minute epoxy. Remove the right panel
and clean off any epoxy that seeped out from
the joint.
23