Dynaflite DYFA3040 - Manual (Page 22)

1—1 19. Glue the leading edge skin that you
prepared in step 2 to the top spar, ribs and LE
using aliphatic resin. The sheeting extends to
the center of the spar.
Ql [-1 24. Glue the landing gear's 5/8" x 1" x 1"
maple stub block to W2 using 30-minute epoxy.
The block fits into the long cutout in the 1/8" ply
doubler. The groove faces W2.
I-] Q 20. Using 3/32" x 1/4" x 30" balsa, cut, trim
and glue cap strips on the tops of ribsW4 -W12.
Cut the longer pieces first.
Q Q 25. Check the fit of the 1/2" x 1" x 8-1/2"
maple landing gear rail in ribsW2,W3 andW4.
When satisfied with the fit, glue it in place with
30-minute epoxy.
Ul Q 21. After the glue has fully dried, remove
the wing from the building board.
Q Q 22. Carve and sand theTE and LE to blend
with the bottom of the ribs as you did in steps
15 and 18.
Q Q 23. Trim the LE and TE sheeting and the
spars even with ribsW1 and W12.
Ql Ql 26. Fit and glue the die-cut 1/8" ply webs
to the front of the landing gear rail using
30-minute epoxy.
22