DLE 20 - Manual (Page 5)

5
Installation Instructions
Prepare the engine for installation
Before beginning installation it’s a good idea to plan location of the
various components of the engine. Many of the following steps may
need to be completed in a different order than listed.
1. Check to see that all screws and bolts are tight. Check carefully
for any cracks, broken, or missing parts. Tighten or replace any
damaged or missing parts before proceeding.
2. Install the silicone wire cover over the pick up lead coming from
the engine (cut the excess silicon wire cover) and connect the lead
to the pick–up lead from the Electronic Ignition Module. Secure
the connection with the included three pin connector securing clip.