DLE 20 - Manual (Page 11)

11
Install the Propeller
1. It is recommended that you test-run, tune, and/or break-in the
engine before fl ying. To make this easier we recommend that you
remove the cowling.
2. Set the engine near the beginning of the compression stroke.
Note the position of the ignition magnet with the engine inverted.
3. Place the spinner back plate
on the engine and the propeller
on the crankshaft at the one
o’clock position.
4. Install the prop washer
and 8x1.0mm adapter nut
(DAVQ9810) on the crankshaft.
5. Install the spinner cone. Be
sure to use thread locker on the
spinner bolt.
3
4 5