Use a null-modem cable to connect the ses1-eia, Use a serial-to-parallel cable to connect the p, Verify that the driver has been installed with – Comtrol SCO OpenServer User Manual
Page 31: Disable /dev/ttyr0a, Edit /comtrol/rckt/tprint.cfg and add the follo, Run /comtrol/rckt/psetup -t, Run /comtrol/rckt/psetup, Enable /dev/ttyr0a, Enter this command, Login on the terminal and cat files to the pri
Configuring Printers
31
SCO OpenServer
Testing Transparent Print
The following example uses an IBM InfoWindow II 3153 and an Epson
LQ-510 printer. Copy and adapt these procedures as needed.
The terminal is set up as follows:
emulation=wyse60
enhanced mode=on
commmode=full duplex
Host/Printer=EIA/None
EIAbaud=38400
AUXbaud=38400
EIAdata=8/1/N
AUXdata=8/1/N
1.
Use a null-modem cable to connect the SES1-EIA port on the
terminal to RocketPort Board 1, Port 0 (ttyr0a).
2.
Use a serial-to-parallel cable to connect the printer to the SES2-
AUX port on the terminal.
3.
Verify that the driver has been installed with transparent print
feature enabled and a port speed of 38,400.
4.
Disable /dev/ttyr0a.
5.
Edit /comtrol/rckt/tprint.cfg and add the following lines:
device=tpr0a
auxon=(esc d #)
auxoff=(dc4)
printcps=90
option=onclr
6.
Run /comtrol/rckt/psetup -t.
The program should return (test mode). If it does not, resolve the
error conditions and try again. Repeat until tprint.cfg is error-free.
7.
Run /comtrol/rckt/psetup.
8.
Enable /dev/ttyr0a.
9.
Enter this command:
ls> /dev/tpr0a
This should print a listing of the present working directory on the
printer, without printing to the terminal screen.
10. If desired, print man pages, or cat text files to /dev/tpr0a to further
test the printer.
11. Login on the terminal and cat files to the printer. The terminal
should work without stopping while printing is in progress.