Comtrol SCO OpenServer - Manual (Page 30)

30 Configuring Printers
SCO OpenServer
PSETUP
After tprint.cfg has been set up, run the psetup program to transfer the
tprint information to the device driver. The syntax is:
/comtrol/rckt/psetup
This program also includes a test mode. To use it, enter:
/comtrol/rckt/psetup -t
Psetup will verify the statements in tprint.cfg but not update the
driver. Any errors found are listed by tprint.cfg line number.
Psetup can be run any time after booting, and may be run repeatedly.
If transparent print is being used on a regular basis, psetup should be
run from the proper rc file after the load program.
Table 11. ASCII Control Code Mnemonics
Mnemonic
ASCII
Code
Mnemonic
ASCII
Code
ack 06h etx 03h
bel 07h ff 0Ch
bs 08h fs 1Ch
can 18h gs 1Dh
cr 0Dh ht 09h
dc1 11h lf 0Ah
dc2 12h nak 15h
dc3 13h nul 00h
dc4 14h rs 1Eh
dle 10h si 0Fh
em 19h so 0Eh
enq 05h soh 01h
eot 04h stx 02h
esc 1Bh sub 1Ah
etb 17h syn 16h
eot 04h us 1Fh