Syslog configuration – Comtrol ES8510-XTE User Manual
Page 113
RocketLinx ES8510-XTE User Guide: 2000574 Rev. C
SysLog Configuration - 113
Configuration Using the Web Interface
SysLog Configuration
The System Log provides the system administrator ES8510-XTE events history. There are two System Log
modes provided by the ES8510-XTE, Local mode and Remote mode.
When enabling Local or Both modes, you can monitor the system logs in the Monitor and Diag /Event Log
page.
System Event
Warning Event is sent when….
SFP DDM Failure
The information read from the DDM SFP transceiver is over temperature or
out the range of TX/RX power.
Port Event
Warning is sent when…..
Link-Up
The port is connected to another device.
Link-Down
The port is disconnected. For example, the cable is pulled out or the opposing
devices is down.
Both
The link status changed.
Apply
Click Apply to apply the settings.
Note: You must Save the settings (
), if you want to maintain these
settings if the ES8510-XTE is powered off.
Warning - SysLog Configuration Page
Syslog Mode
There are two system logs available:
•
Local Mode: The ES8510-XTE prints the events that have been
selected in the Event Selection page to the System Log table of
the ES8510-XTE. You can monitor the system logs in the
Monitor and Diag /Event Log page.
•
Remote Mode: Assign the IP address of the System Log server.
The ES8510-XTE sends the events that occurred in the
selected in Event Selection page to System Log server that you
assign.
•
Both: This enables both Local and Remote modes.
Remote IP Address
The IP address of the System log server.
Apply
Click Apply to apply the settings.
Note: You must Save the settings (
), if you want to
maintain these settings if the ES8510-XTE is powered off.