Comtrol 500 DeviceMaster - Manual (Page 41)

DeviceMaster 500 User Guide: 2000501 Rev. A Managing the DeviceMaster 500 - 41
Managing the DeviceMaster 500
This section discusses the following DeviceMaster 500 maintenance procedures:
• Rebooting the DeviceMaster 500
• Uploading SocketServer to Multiple DeviceMaster 500s on Page 42
• Configuring Multiple DeviceMaster 500s Network Addresses on Page 42
• Using Configuration Files on Page 43
• Managing Bootloader on Page 44, which also discusses checking the
Bootloader version and downloading the latest Bootloader
• Adding a DeviceMaster 500 to an Existing Installation on Page 46
• Replacing a DeviceMaster 500 on Page 46
• Restoring Serial Port Settings on Page 47
Note: You can optionally refer to RedBoot Procedures on Page 49 if you want to
perform procedures at the RedBoot level.
Rebooting the DeviceMaster 500
There are many ways to reboot the DeviceMaster 500. Use the method that most
fits your situation.
Optionally, you can power cycle the DeviceMaster 500.
Method Procedure
PortVision Plus
Main screen: Right-click the DeviceMaster 500 or
DeviceMaster 500s, click Reboot Device and then Yes.
Configure Device screen: Click Reboot Device and then Yes.
Web page
Main page: Scroll to the bottom of the screen, click Reboot
and then Yes: Reboot.
Telnet Type reset.