Precautions for the safe use of batteries, Putting the batteries into the remote controi unit, Using the remote control – JVC CA-V605T User Manual
Page 9: Before using for the first time, Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE USING FOR THE FIRST TIME
Putting the batteries into the remote
controi unit_____________________
The battery compartment is located on the back of the remote
control.
1. Press down on the triangular mark of the compartment
cover, and slide the cover off to open the compartment.
2. Place the two accessory R6P (SUM-3)AA (15F) batter
ies in the remote control according to the polarity
markings (“+” and inside the compartment and on
the batteries.
3. Place the cover over the compartment, press down
lightly, and push it upward until it snaps on.
The batteries last about one year with normal use. If function
of the remote control become erratic, replace the batteries.
See “Precautions for the safe use of batteries” below for more
information.
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries.
Their life will be shortened, they may burst or their contents
may leak if they are used improperly:
• Remove batteries from the remote control if it is not going
to be used for a long period of time.
• Remove dead batteries and dispose of them properly.
• Never leave dead batteries lying around, take them apart,
mix them with other refuse, or throw them into an incinera
tor.
• Never touch liquid that has leaked out of a battery.
• Do not mix new and old batteries, or batteries of different
types, when replacing them.
Using the remote control_________
The remote control is ready to use when its batteries are
installed properly.
To use it, point its infrared light-emitting window toward the
display window of the System and press a button. The oper
ating range of the remote control is up to about seven meters
in front of the System and within about 30 degrees to each side
— with nothing between the remote control and the System
interrupting the beam path.
If pressing a button on the remote control does not produce
any response, check to make sure it is pointed correctly and
try again. If it still does not function, check the batteries.
—
ii.............................. ..... '*
^
'
1
—
*1
J _. -iJs“ ...a
\ o ^ \
Page 5