Presetting stations, Operation, Press set – JVC CA-V605T User Manual
Page 24: Press prev/next to select a channel number, Press set again, Tuning in a preset station, Press fm/am, Press and hold prev/next until the channel, When using the remote control, To erase the preset stations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AM-FM TUNER
Presetting stations
You can preset 10 stations each for FM and AM.
Operation
1. Press (^) FM/AM button and then TUNING - or + to
tune in the station you want to preset.
See ‘Tuning in a Station” on the previous page.
2. Press SET.
The MEMORY indicator blinks for about 5 seconds.
3. Press
PREV/NEXT to select a channel number
while the MEMORY indicator is blinking in the display.
4. Press SET again .
The MEMORY indicator goes off in the display.
Tuning in a preset station_________
Operation
1. Press FM/AM.
The unit automatically turns on and tunes in the most recent
station (either FM or AM).
Each time you press the button, the band alternates be
tween FM and AM.
2. Press and hold
PREV/NEXT until the channel
number you want appears in the display.
When using the remote control
You can select a preset station directly by specifying its
channel number.
To erase the preset stations
Storing a new station on a used number erases the previously
stored one.
Note
When you unplug the AC power cord or power failure occurs,
the preset stations will be erased in afewdays. If this happens,
preset the stations again.
Operation
1. Press US FM/AM.
The System automatically turns on, and then by pressing
the FM/AM button, the System will switch from the most
recently selected FM or AM station.
2. Press the number button (1 —10) to select your preset
channels.
Note
If you want to use the number buttons on the remote control to
select the preset radio stations, you must select FM or AM from
the remote control’s FM/AM button.
Page 20