JVC CA-V605T - Manual (Page 23)

AM-FM TUNER
Before listening to FM and AM broadcasts, check the follow­
ing:
• Both the FM and AM antennas are firmly connected.
• Check the AM tuner interval spacing (9 kHz or 10 kHz) for
your area.
Setting the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
When shipped, the built-in AM tuner is set to 9 kHz spacing.
To set the AM tuner to the 10 kHz spacing, be sure that the
unit is turned off, but is plugged into a wall outlet. Hold down
►w NEXT and then press POWER.
To set it back to the 9 kHz spacing, be sure that the unit is
turned off, but is plugged into a wall outlet.
Hold down PREV and then press POWER.
When using the remote controi unit
Pressing FM/AM button, FM or AM automatically turns on the
remote control and starts tuning in the most recent FM or AM
station respectively.
Note
When you press TUNING - or + briefly and repeatedly, the
frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy,
press AUTO/MONO on the remote control, so that the AUTO
indicator goes off in the display. Reception improves, but there
are no stereo effects. In this monaural mode, static is produced
(since muting is also canceled).
To restore the stereo effect, press AUTO/MONO so that the
AUTO indicator lights up. In this stereo mode, static is not
produced, and you can hear stereo sounds when a program is
broadcast in stereo.
Tuning in a station
Operation
1. Press (^1 FM/AM.
The unit automaticaily turns on and tunes in the most recent
station (either FM or AM).
Each time you press the button, the band alternates be­
tween FM and AM.
Press and hold TUNING - or +.
The unit starts searching stations and stops when a station
of sufficient signal strength is tuned in.
The TUNED indicator lights up in the display. If a FM
program is broadcast in stereo, the STEREO indicator also
lights up.
To stop during searching, press TUNING - or +.
Page 19