JVC CA-V605T - Manual (Page 6)

BEFORE USING FOR THE FIRST TIME
Connecting the antennas_________
FM antenna
Antenna preparations
You need to connect the FM antenna to the back ot the
System.
• Open the FM antenna wire connectors by pushing them to
the side, insert the FM antenna wires, and close them by
pushing them back into their original position.
* Hang the FM antenna on the wall behind the System.
AM antenna
1. Connect the AM loop antenna to the AM LOOP termi­
nals as illustrated.
2. Turn the AM loop antenna until you have the best
reception.
To connect an outside AM antenna
When reception is poor, connect a single vinyl-covered wire to
the AM EXT terminal. (The AM loop antenna must remain
connected.)
For better reception of both FM and AM
Make sure the antenna conductors do not touch any other
terminals or connecting cords.
Keep the antennas away from metallic parts of the System,
connecting cords, and the AC power cord.
Page 2
Connecting the speakers_________
The speaker cords are included with the speaker system.
Speaker connections
(Both speakers should be connected)
1. Remove the insulation at the end of each cord and twist
the core of the cord.
Pull
Twist
2. Open the speaker terminal.
3. Insert the end of the speaker cord to the terminal.
For each speaker, connect one end of the speaker cord to
the speaker terminals on the rear of the System. Match the
polarity of the speaker terminals: Red (-i-) to red (- h ) and
black (-) to black (-).
4. Close the speaker terminal on the rear of the System or
just re-lease your finger from the terminal on the
speaker.
Rear panel
------- SPEAKERS ---------------
RIGHT LEFT