Toshiba MA-191 - Manual (Page 64)

3) To reset the rate once set:
| 0 | -
i2i
SETTING THE % RATE ON ISI/TLI KEY {Condition: after a Z reset)
This operation is effective only when the "SI/TL AFFECT M.I. TL" option
is selected.
Mode Lock; SET
{% RATE
Key Operation:
-»ISI/TLl
max. 99.99%
(Use the [7] key if
the rate contains
a decimal point.)
NOTES; 1. The fraction resulted from the % calculation is processed
in the same way as selected for the i%+I and |%-| keys.
2. To reset the rate once set, operate in the SET mode:
lo|->^rsi7TLl
SETTING HOURLY RANGES (Condition: after a Z reset)
Mode Lock: SET Key Operation:
| 4 | — —
1 or 2 dig. 2 dig.
HOUR |MINUTE]->|il —lAT/TL
^ I
(the time to end
each hourly range,
in the 24-hour
system)
Repeat until all
the time ranges <-
are entered.
NOTES: 1. A maximum of 24 hourly ranges may be set.
2. To change the table of hourly ranges once set, partially
or entirely, do the entire setting operation over again.
3. To reset the hourly range table once sej^: _______
Mode Lock: SET, 141 j@7 f 0R I -»101 I#~[ -»l AT/rTi
4. Do not set an hourly range across 24:00, such as "from 23:00
to 1:00".
- 60 -