I —»i – Toshiba MA-191 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROGRAMMING TAX TABLE (Condition: after a Z reset and GTZ reset)
Mode Lock: SET
1) TAX 1 FULL BREAKS
Key Operation: |max. amount non-taxable] —> ITXl/MI
I max, amount for tax levied| —^\TXl/MI
I
max. amount for 2^ tax levied I I T X l / M I
Repeat until the "A" Break is entered.
I max, amount for tax levied|
1TXl/^.••"A" Break
fST^I (to indicate the "A" Break entry)
I
max, amount for N+l(gi tax levied | \ TX1/M~|
I
max. amount for N+2fi tax levied
I —»I
TXl/M |
Repeat until the "B" Break is entered.
IAT/TL1 (to end)
NOTE: The amount etnry may be maximum 4-digit value (up to 9999(/).
2) TAX 1 *'A'* BREAK AND % RATE COMBINATION
Key Operation; First set the "A" Break following the same operation
up to the "A" Break entry and the 1 ST| key depression
in ”1) TAX 1 FULL BREAKS" above.
1
I TAX RATE applied when exceeding the ’*A" Break amount
(max. 4 digits, up to 99.99%. Do not use the Q
key. The fraction of the amount resulted from this
%
rate calculation will be rounded off.)
I
IAT/T
l
1 (to end)
3) TAX 1 % RATE ONLY
Key Operation:
I
0
I
—» 1
t
1
q
/M
I
-»jTAX RATE|-»iAT/TL|
(The conditions
of the rate are
the same as the
above TAX RATE.)
NOTES: 1. If only one tax modifier key ( |~T
x
7
m
] ) is installed on the key
board, use the |TX/M
1
in place
of
the
j
TXl/M
I
in the descrip
tion 1), 2), or 3) above.
- 56 -