RCA VR634HF - Manual (Page 13)

SETTING UP THE VCR
A U T O C H A N N E L S E A R C H
W h a t t y p e o f s i g n a l
a r e y o u u s i n g ?
1 C a b l e T V
Z A n t e n n a
3 > D e t e c t A u t o m a t i c a l l y
0 C a n c e l
4. Select one of the three AUTO CHANNEL SEARCH options:
• Cable TV searches for cable channels
• Antenna searches for local broadcast stations
• Defect Automatically will make this decision for you
A U T O C H A N N E L S E A R C H
N o w s c a n n i n g c h a n n e l 1 4
P r e s s a n y k e y t o c a n c e l
The VCR begins scanning for the available channels—this
takes about one to two minutes. When the scan is complete,
the VCR tunes to the lowest channel number. At this point,
pressing CHAN up or down on the remote control or VCR
should only select the active channels.
CHANGING THE SIGNAL TYPE
1. Press MENU to display the VCR MAIN MENU.
2. Press 4 to display the CHANNELS menu.
C H A N N E L S
1 A u t q C h a n n e l S e a r c h
2 A d d / R e m o v e C h a n n e L s
3 S i g n a l T y p e : C A B L E
4 V C R P l u s + C h a n n e l L i s t
5 C a b l e B o x S e t u p
0 E x i t
3. Press 3 to change the Signal Type between CABLE and
ANTENNA.
Detect Automatically
A strong cable or antenna signal in
your area may cause Auto Detect to
mis-detect. If this should happen,
select 1 or 2 for the system you have.
11