Startup, Setting up the vcr – RCA VG4038/ VG4039 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up the VCR
Startup
5. Place channels In the VCR’s memory.
Channels 2 through 13 including line input (L) are in the VCR's"
memory when you first turn it on. Pressing CHANNEL up or down
stops on these channels. To get additional channels available on
your antenna or cable system, you must use the Auto-Search
Channels feature of the VCR. If you ever change cable or antenna
signals, you may need to Auto-Search channels again.
A. Press VCR1 to set remote to control VCR.
B. Press MENU»PROG on the remote to see the VCR MAIN MENU
on the TV screen. If the menu does not appear on the TV screen:
•
Make sure TV is tuned to same channel as CH3 CH4
switch on VCR or the TV's video input (refer to TV's
manual).
•
Press VCR1 and then press MENU»PROG.
•
If you use a basic hookup, check VCR indicator in display
panel — it should be on. Press TV»VCR to turn it on.
•
Check the connections.
C. Press 4 to select CHANNEL SETUP.
D. Press 1 to begin Auto-Search Channels.
Wait until the channel numbers stop changing. This takes about
one to two minutes. The TV will then tune to the lowest channel
found. Pressing CHANNEL up or down will select only the
active channels.
The VCR automatically selects ANTENNA or CABLE of the
Tuning Mode feature in the CHANNEL SETUP menu. If you
need to change the setting manually, press 3.
VCR MAIN MENU
1 VCR Plus+ Programming
2.Timer Programming
3 Review Programs
4 Channel Setup
CHANNEL $ ETUP
1
Auto-Search Channels
2 Add/Remove
Channels
3
Tuning Mode : ANTENNA
4 Sat. /Cable Box Setup
0
Exit to Mai n Menu
6. Add or remove channels from the VCR’s memory.
You may want to add or remove channels if some of the channels are
not active, have weak signals, or you do not want to watch them.
A. Press VCR1.
B. Press MENU«PROG on the remote to see the VCR MAIN MENU
on the TV screen.
C. Press 4 to display the CHANNEL SETUP menu.
D. Press 2 to display the ADD/REMOVE CHANNEL menu.
E. FoUow the directions on the screen.
F. Add or remove more channels'by entering channel numbers or
using CHANNEL up and down buttons.
VCR MAIN MENU
1 VCR Plus+ Programming
2 Timer Programming
3 Review Programs
4 Channel Setup
CHANNEL SETUP
1 Auto-Search Channels
2 Add/Remove Channels
ADD/REMOVE CHANNEL
CH 03
i s presently ADDED
Press CLEAR to remove
Press MENU to exit
8