Kenwood 1070VR - Manual (Page 6)

107DVR/1GSOVR (En/KJ
Frequency display,
Input display,
Preset channel display,
Surround mode display Band indicators
SURROUND M.INPUT indicator
indicator {107QVR only)
DSP indicator
TP SP. C! ES -
PUT M№
p —' rii
- MFMORY indicarnr
Speaker indicators
~T
AUTO indicator
—I
— STEREO indicator
- TUNED indicator
3 STEREO indicator
S-DIRECT indicator LOUDNESS indicator
C^^Display^
0 © Q O 0 9
® 0 0 0 0 0 0 00 0 0 000
O POWER key 0 DSP key -Qji 0 TUNING keys
Use to switch the power ON/STANDBY. Use to turn on, or switch, the DSP mode. Use to tune in radio broadcasts.
O Numeric keys 0 INPUT SELECTOR knob 0 BASS k^y -iffl
O STANDBY indicator Use to select the input sources. Use when adjusting the bass tone
O LEVEL indicator 0 VOLUME CONTROL knob © TREBLE key
Lights when the level of the signs 1 being 0 PHONES jack Use when adjusting the treble tone.
-incut Is trao hiah- Use for headphone listenlnq. © LEVEL CONTROL keys
@ MUTE indicator © SPEAKERS A/B keys Use to adjust the level of The selected
@ LOUDNESS key Use to turn the speakers ON/OEE tone,
Use to activate the frequency weighting © DIRECT key 0 DIMMER key
network Use to tune radio stations directly by nu- Use to adjust the brightness of the display.
O STEREO key mencal input, 0 CENTER MODE key
Use to cancel the surround mode. 0 MEMORY key Use to select the center mode
0 PRO LOGIC key Use to store radio stations in the preset © MUTE key
Use to turn on the DOLBY PRO LOGIC memory. Use to mute the sound.
mode O AUTO key —L¿3 ® SOURCE DIRECT key
O DOLBY 3 STEREO key Use to select the auto tuning nnode. © AV AUX jacks
Use to turn on the DOLBY 3 STEREO 0 BAND key
nnode. Use to select the broadcast band.
About the STANDBY indicator
Thif^ unit a STANDBY inriiratnr Whpn thp STANDBY indinatnr \p, lit. thfi unit mnstimns pi small amount of powor To praRorv« The
memory. This is called STANDBY mode This mode also lets you turn the power ON using the remote control.