Listenina to a source component, Turn on the receiver, Start playback from tite selected source – Kenwood 1070VR User Manual
Page 19: The input sources change as shown below, C2j "phono'tphono"*)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1 Q70Vf!/1 OSOVR |En/K]
PrBpsrStionS
‘Turn on the power to the related compo
nents.
Listenina to a source component
Turn on the receiver.
Ktiys or conurols used In this operation.
•ill liJ
Start playback from tite selected source.
A ON
: Sound from the speakers connected to the SPEAK
ERS A terminals on the rear panel.
B ON
: Sound from the speakers connenteri to the .SPEAK
ERS B terminals on the rear panel.
A-i-B ON
: Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A-
e
B
off
: No sound from the speakers
Use
thi.s .settinr)
when
listening with headphones for stereo sound in si
playback modes.
•When both SPEAKERS A and B are ON activatino
a
surrnunrl morTe
turns SPEAKERS B OFF automatically.
The input sources change as shown below:
CD TUNER
(Frequency display)
C2J
"PHONO'TPHONO"*)
(3)
"VIDEOr ("SAT"*)
® "VIDE02” ("LD"*)
® "VIDEOS" rVCR"*}
® "AV AUX"
@ "CD" ("CD"*)
® "TAPE/MD" ("TAPE"*)
• Once itrup uudesare leyisiered in irie remote control, the input name
display changes according to the name of the registered component.
Example: if you register a VCR at the VIDEO 1 jacks,
"VCR1"
appears
instead of
"VIDEO TV
•When using the remote control after initial setup, any inputs that have
not been registered with a setup code are deleted from the cyclic list
(except for the "AV AUX" VIDEO input),
• The
INPUT SELECTOR
on the front panel of the receiver always cycles
Lliruuyli ali jripuib.
Volume display
I / n I
1/ L J L
c
ri „.17:i
U L..I L.I ..U