Kenwood 1070VR - Manual (Page 40)

Hold your remote to the speaker portion of
your telephone.
» For each setup code the operator can supply a setup code number.
Should you ever need to change your input configuration, this number
can be used. Please record foryourfuture reference. If for some reason
this information is lost, see "Checking a setup code" in the "Setup code
correlation" section lor further information.
Code selection after mode download
After successful completion of the download, step 5 above, the remote control automatically enters a special set-up mode which works
as described below.
Select the component for which you want
to register the information downloaded
above.
VIDEO key
^ Ф VIDE01 (VCR 1)
® VIDE02 (VCR 2)
— Гз) VIDEOS (LD)
AUDIO key
® CD (CD)
@ TAPE/IVID
(TAPE)
CD PHONO
TV key
Г» C0TV1
CD TV2
L- CD CABLE
* Example 1 : To register a code at the component connected to the
VIDEO 1 jacks, select "VIDEO 1 (VCnr
Perform each of the following steps within
5 seconds.
Press a numeric key.
Repeat steps 1 and 2 to register all of the
downloaded information.
^ Hold down the ENT key until the backlight
flashes twice.
» Press the 1 key to output the POWER code of the first component on
your list in step D of the previous page. Continue to push buttons 2
through 9 (and 0) until the component you want to register turns on.
»Though the FutureSet memory in your remote control is quite large,
only 10 setup POWER codes can be put on the 10 keypad at any one
time. If you require a larger download, the standard setup procedure
can be used. See "Registering setup codes for other connponents", your
customer service representative can supply you with the downloaded
setup code numbers.
■I
»The setup code for the last POWER code to be sent in step B is
automatically registered at the location selected in step □.
»At this time, the remote exits the special set-up mode and returns to
itc normal oporation mode,