Low battery warning, Ur remote control – Kenwood 1070VR User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
.............. ...... '............. ................ ............................................................................................................................ '.... .........................
ur remote control
j-, ì.^^..
«''■>■.' -f ■;
1070VR/iaeOVR [En/K|
The remote control supplied with this receiver is also capable of controlling components from a variety of manufacturers once
you register the appropriate setup codes into the remote control unit.
Refer to "Remote operation of other components" for details about the operations available for each component. -BS
* When registering setup codes for KENWOOD audio components which are connected to this unit by system control cords, use the
following codes to insure proper system control operation: Cassette: 7000, CD: 8099, MD: 9000.
-SE
Tc control otiner KENWOOD components (VCRs, LD players, audio components not connected with system control cords, etc.} follow
the procedure described below.
Low battery warning
Reolsce all four batteries with new ones when you notice a shortenina of the distance fronn which the remote control will operate or if the remote control
blinks
5
times when you push a key. The remote control is designed to retain set up codes in memory while you change batteries. Failure to change
batteries after receiving the 5 blink battery warning signal may cause all the memory to be lost (l 060VR only),
Find the setup code of the component to be
registered.
Refer to the eetup code lists to find the setup code for the
component to be registered.
Example: To register a CD made by KEhfWOOD, you would
enter"8037”
If you purchase a new component that is not covered by the
setup code llstr you can use the PutureSet upgrade feature
(1070VRonly).
Hold down the ENT key until the backlight
flashes twice and remains lit.
Input
Component
Maker
Code
Key
(CD)
CD player
KENWOOD
9626, 8037
AUDIO
VIDEO 1
VIDEO ?
VIDEO 3
TAPE/MD
CD
PHONO
—
TV 1
-
TV 2
-
CABLE
• At this time ali inputs become available regardless of any earlier
registration.
Perform each of the following steps within
5 seconds.
VIDEO key
$ VIDE01 ISAT)
S VIDE02 (LDl
C33 VIDEOS (VCRI
AUDIO key
® CD (CD)
® TAPE/MD
(TAPE)
® PHOIMO
TV
key
® TV1
®
TV2
@ CABLE
■
Example
; To
rogistor the eonnponent oonneeted
to
the VIDEO 1 jacks,
select "VIDEO 1 (SAT)".
t
i
l
l
I I I