Canon DIGITAL VIDEO CAMCORDER MD130 - Manual (Page 31)

Playback
Bas
ic
F
unc
tions
31
5
Push the joystick ( ) towards /
to begin the playback.
D
URING PLAYBACK
6
Push the joystick ( ) towards
/ again to pause the playback.
7
Push the joystick ( ) towards to
stop the playback.
T
O ADJUST THE VOLUME
1
Press .
2
Select ( ) [ SPEAKER
VOLUME] and adjust ( ) the
volume.
• The sound from the built-in speaker
will be muted when you close the LCD
panel or while the STV-250N Stereo
Video Cable is connected to the AV
terminal.
• If you turn off the volume completely,
the icon will change to
.
3
Press to close the menu.
S
PECIAL
P
LAYBACK
M
ODES
To operate the special playback modes
use the buttons on the wireless
controller*. There is no sound during the
special playback modes. To return to
normal playback, push the joystick (
)
towards / or press on the
wireless controller*.
Fast Playback: Push the joystick ( )
towards or ( ) towards . Hold
the joystick pressed down to rewind/fast
forward the tape while continuing the
playback. You can also press and hold
or on the wireless
controller*.
Reverse Playback: During normal
playback press .
Frame Reverse/Advance: During playback
pause press / . Keep pressed
for continuous frame-by-frame playback.
Slow Playback: During normal or reverse
playback press .
Double Speed Playback: During normal or
reverse playback press .
*The wireless controller is included only
with the
.
NOTES
You can display the date and time of the
recording (
53).
During some special playback modes, you
may notice some video problems (blocky video
artifacts, banding, etc.) in the playback picture.
To protect the tape and video heads, the
camcorder will enter the stop mode (
) if left in
playback pause ( ) mode for 4 minutes 30
seconds. To resume the playback push the
joystick (
) towards / .
Returning to a Pre-marked Position
If you wish to return to a particular scene
later, mark the point with the zero set
memory and the tape will stop at that
point when you rewind/fast forward the
tape.
1
While recording or during playback,
press on
the
wireless controller at the point you
wish to return to later.
• The time code changes to
“0:00:00
”.
• Press again to
cancel the memory.
2
If you marked the zero memory
while recording, set the camcorder
to
mode. If you marked
the zero memory during playback,
press .
3 Press to locate the zero mark.
• If the tape counter shows a negative
number, press
instead.
• appears and the camcorder
rewinds/fast forwards the tape.
FUNC.
FUNC.
PLAY
REW FF
SLOW
( 8)
ZERO SET MEMORY
ZERO SET MEMORY