Brother FAX-195 - Manual (Page 31)

25
F. Setting the TAD security code
The TAD security code is a three digit number that is designed to prevent unauthorized remote
access to the messages recorded on your TAD. The factory setting is 000. To set your own
code, follow this procedure:
1. Turn the power OFF.
"CAUTiON: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE EVENT
OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER SWITCH."
2. Press the HOOK button and keep it depressed until FINE lamp blinks as you turn the
power back ON.
3.
4.
5.
6.
7.
8 .
9.
Press the FINE/PHOTO button four (4) times to select the TAD Security Code Set
Mode.
Press the START/COPY button to print out the current security code. You will see:
**** *********CURRENT TAD SECURITY CODE*********************
* *
* TAD SECURITY CODE: 000
* *
*********************w***gpQ1-|_j^|;^ FAX ■] Q^***************************
To register a new TAD Security Code, say, 104, press FINE/PHOTO button once to
select the first digit "1".
Press START/COPY button to register this digit.
Press START/COPY button (don't touch the FINE/PHOTO button) to register "0".
Press FINE/PHOTO button four (4) times to select the final digit "4".
Press START/COPY button to register this final digit and the FAX-195 will
automatically print out:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE?
*
* NEW TAD SECURITY CODE: 104
*ifki(ieickitici(***ieicieic-kic*****itiie* ■ kic***-k*ie-kicicicitirkicicici(*ie***ic*1cic BROTHER FAX-195
The START/COPY lamp will start to blink when the printout is finished.
10. If your entries are incorrect, press the STOP button and then the START/COPY
button. The FINE lamp will start to blink. This will bring you back to step 3 where you
can select this procedure all over again.
If your entries are correct, press the START/COPY button to complete the selection
of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other parameters. To do so, you press START/COPY button again
which will bring you back to step 3 above and where you can use the FINE/PHOTO
button to select the desired parameter. Choice (2) is to terminate the registration
process by pressing the STOP button.