Facsimile-related programming operations – Brother FAX-195 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FACSIMILE-RELATED PROGRAMMING OPERATIONS

Unlike most other facsimile units in this class and price range, the FAX-195 allows the user to

program certain facsimile functions and parameters. These are:

The FAX Password Code (for password communication discussed above).

II.

Remote Terminal Identification (RTI) / Transmit Terminal Identification (TTI) telephone
number. This is the number that appears on the top of the page when the other party
receives your message.

III. The Station ID (name or identifying numbers). This appears on the top of the page

when the other party receives your facsimile communication.

IV. User-selectable parameter settings (User-selectable Switches)

Telephone and TAD (Telephone Answering Device)-related programming is discussed in the
subsequent section.

The programming is done using one or more of the following buttons:

HOOK
FINE/PHOTO

START/COPY -

STOP

Initiates parameter-setting operation

Selects numbers from 1 to 9
Enters (registers) numbers selected by the FINE button
Lists parameter set status after setting
Selects the number 0
Completes or interrupts the programming/selection process

The general programming procedure

The general procedure for setting any parameters (programming the functions) is:

Turn the power OFF (the switch is in the back of the unit)

"CAUTION: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE EVENT
OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER SWITCH."

Press the HOOK button and keep it depressed until FINE lamp starts to blink as you

turn the power back ON.

Press the FINE/PHOTO button —

1 time

2 times
3 times
4 times
5 times

To select the FAX PASSWORD SET mode
To select the RTI/TTI SET mode
To select the STATION ID SET mode
To select the TAD SECURITY CODE SET mode
To select the NUMBER OF ICM SET mode

Then, the START/COPY lamp blinks.

NOTE: The unit will go back into the stand-by (idle) status if any of the above buttons are not
pushed within 60 seconds.

* This operation is related to the telephone and TAD operations and is discussed in a subsequent
section.