Winding the bobbin – Kenmore 1660 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WINDING THE BOBBIN
0
0
0
'i,
' '''' y*-a
V
"-r
i
I
•f'tt
iii!
1.
Release clutch by turning clutch
knob toward you.
2.
Draw thread from spool through
bobbin winder tension disc as
shown.
3. Pull end of thread through hole in
bobbin as shown.
4. Place bobbin onto bobbin winder
shaft with end of thread coming
from the top of the bobbin. Push
bobbin winder latch against bobbin
until it clicks. Holding onto end of
thread, start nhachine. When bobbin
is slightly filled, snip off end of
thread.
5. Start machine. Wind thread until
bobbin winder latch releases.
6. Tighten clutch knob and remove
bobbin.