beautypg.com

Adjusting top thread tension, Adjusting bobbin thread tension – Kenmore 1660 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

STRAIGHT STITCHING

Under

side

Well balanced

Top stitch

too tight

X

.

D«cr«s«« IncrMM

tension tension

Top

Stitch

too loose

ZIGZAG STITCHING

Fabric
puckers

ADJUSTING TOP THREAD

TENSION

STRAIGHT STITCHING

The good looking appearance of your
stitching Is largely determined by the
balanced tension of both top and bobbin
threads. The tension is well balanced

when these two threads 'lock' In the
middle of layers of fabric you are
sewing.

If, when you start to sew, you find that
the stitching is Irregular, you will need to

adjust the tensron control.

Make any adjustments vyith presser foot
'down'.

1. If the threads are locking on the top

surface with the top thread lying flat,
the top stitch is too tight. Tension
can oe decreased by turning the

tension control to lower numbers.

2. If the reverse is happening with the

threads on the underside of the
fabric, (fie tension is too loose. This

can be corrected by turning the
tension control to higher numbers.

ZIGZAG STITCHING

The top thread may appear on the
bottom depending on the thread, fabric,
type of stitch and sewing speed, but the
bobbin thread must never appear on the
top of the fabric.

ADJUSTING BOBBIN
THREAD TENSION

BOBBIN THREAD TENSION REQUIRES

ADJUSTMENT

LESS

FREQUENTLY

THAN THE TOP THREAD TENSION.

If the tension is well balanced, but the

fabric puckers badly, both top and
bobbin thread tensions may be too tight
and have to be adjusted.

When adjusting the tension on the

bobbin case, make only slight adjust­
ments with a srewdriver.

This manual is related to the following products: