Buttonhole making – Kenmore 1660 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BUTTONHOLE MAKING
(Model 1947)
SETTINGS
Step 1. Special Stitch Modifier - Red Dot
Step 2. Special Stitch Dial - □
Stitch Width Control - 4
Stitch Length Control - Red Zone
Zigzag Presser Foot
Zigzag Needle Plate
1. Carefully mark the buttonhole length
on your garment. Mount the button
hole guide onto the presser foot so
that rear edge of presser foot is at
the rear end of the guide, with upper
thread as shown. Place the fabric
wrth buttonhole marked, under the
buttonhole guide.
Without lowering the foot, let the
needle pierce the fabric at the be
ginning of the buttonhole. Lower
presser foot.
Reproduction of the identical size
buttonholes is facilitated with the aid
of the graduations on the left side of
the buttonhole guide.
These graduations are 1/8" apart.
Always start buttonhole with foot
positioned at rear end of the guide.
After first buttonhole is made, al
ways stitch forward to point on front
of guide as with first buttonhole.
Graduations act as reference mark.
32