beautypg.com

Q instali grease tray kit, Grill information center, Checking for lp gas leaks – Kenmore 141.173373 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Q Instali Grease Tray Kit

1. Place Heat Shield into Grease Draining Tray.

The Heat Shield must be present and
centered for your safety. From the back side
of Grill Head, install the Grease Draining Tray
with its drain hole to ieft, which is the side
opposite from the Tank Pull-Out Tray. See

Figure 14.

2. From the front side of cabinet, open the doors

and install the Grease Receptacle under
Grease Draining Tray. See Figure 14.

Figure 14

GREASE DRAINING TRAY

HEAT SHIELD

A

warning

if you smei! gas:

• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Extinguish any open flame such as candle,

cigarette, lighter, etc., that could cause gas
to ignite.

• Open the Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you

cannot extinguish, call your fire depart­
ment. Do not call near the LP gas tank

because your telephone is an electrical
device and could create a spark resulting
in fire and/or explosion.

NOTE: The normal flow of gas through the

regulator and hose assembly can create a
humming noise. A low volume of noise is

normal and will not interfere with operation of

the grill, if humming noise is loud and exces­
sive you may need to purge air from the gas

line or reset the regulator excess gas flow
device. This purging procedure should be
done every time a new LP gas tank is
connected to your grill. For help cali the
Customer Service Helpline.

Grill information Center:
Bam - 8pm CST, Monday through Friday

1-888-317-7642

Congratulations

Your Kenmore gas grill is now ready for use.

Before the first use and at the beginning of

each season (and whenever the LP Gas tank
has been changed):

1. Read all safety, lighting and operating

instructions.

2. Check Gas Valve Orifices, Burner Tubes

and Burner Ports for any obstructions.

3. Perform gas leak check according to

instructions found on page 23 of this
manual.

Checking For LP Gas Leaks

Never test for leaks vwth a flame. Prior to first

use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:

1. Make a soap solution by mixing one part liquid

detergent and one part water.

2. Turn the grill Control Knobs to the full OFF

position, then turn the gas ON at source.

3

. Apply the soap solution to all gas connections.

If bubbles appear in the solution the connec­

tions are not properly sealed. Check each
fitting and tighten or repair as necessary.

4. If you have a gas leak you cannot repair, turn

off gas at the source, disconnect fuel line from
your grill and call 1-800-4-MY-HOME® or your
gas supplier for repair assistance.

23

This manual is related to the following products: