Q fuel gauge display installation, Battery replacement, Fuel gauge display operating - see figure 12c – Kenmore 141.173373 User Manual
Page 21: Note: tank must be positioned in tray for fuel, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Q Fuel Gauge Display Installation.
Open the front Doors of Cabinet. Pull out the LPG
Tank Puli-Out Tray. Connect the Wire Plug "A" from
Fuel Gauge Display with the Wire Plug "B"from rear
of Tank Puli-Out Tray. Unscrew 1/4" x 1/2" Pattern
Head Screw{Lower) from Cart Rear Panel and fix Wire
Plug "A” into Wire Fastener. Install Wire Fastenerto
Cart Rear Panel. Tighten securely using the same
screw. See Figure 12a.
Battery Replacement:
1. Stretch your hand behind Control Panel and
unscrew the Battery Cover behind the Display Box.
2. Puli out the Battery with electricwire from the Battery
Compartment.
3
. Replace the used Battery with the new one.
4. Replace the new Battery with eiectric wire back into
Battery Compartment. See Figure 12b.
5
. Screw the Battery Cover back to the Display Box.
Fuel Gauge Display Operating - See Figure 12c
Press the “CHECK” button to operate Fuel Gauge Dis
play with the Gas Tank mounted in the Tank Pull-Out Tray.
NOTE: Tank must be positioned in tray for Fuel
Gauge Display check
1. Fuel Display: Indicates Gas Tank fill level.
2. FueiWarning Display: When the GasTankfill level
is on the last row, a warning signal will sound for
approximately 3 seconds to warn you that the tank
volume is near empty.
3. Battery Warning Display: A low battery warning
light will i I lum i nate when the battery voltage drops to
a low level. Replace the battery.
NOTES:
1
. The Fuel Gauge Display lasts for approximately 20
seconds each time you press the “CHECK” button.
After 20 seconds, the Fuel Gauge Display turns off
automatically. If you press the button a second time
within 20 seconds, the Fuel Gauge Display will be
turned off manually, if you press the button a sec
ond time after 20 seconds, the Fuel Gauge Display
will work and last for another 20 seconds.
2. The Fuel Gauge Display works only with a tank on
the Tank Pull-Out Tray. No readout will appear if a
tank is not mounted on the Tank Pull-Out Tray.
Figure 12a
IMPORTANT: When the Gas Tank is removed from
the Tank Pull-Out Tray, the fuel gauge display will
not operate.
CHECK
BUTTON
21